MERITS AND DEMERITS OF VERTICAL AND HORIZONTAL ENGINES

Horizontal and vertical engines are identified by the line of the stroke. If the line of stroke of an engine piston is vertical, then it is a vertical engine. The line of stroke of the horizontal engine is horizontal.




































In a reciprocating type of engine, primary and secondary forces of the reciprocating parts exist. These forces act along the line of stroke and depend on the crank position. These primary and secondary forces combine together and give maximum force to the engine crank when the crank is at TDC.

Comments

Post a Comment

Popular posts from this blog

PISTON RINGS

Image
Introduction: Piston rings are provided on the piston. These are used to seal the high pressure side (cylinder) and low pressure side (crank case), i.e. to prevent leakage of gases. There is one oil ring also which is used to scrap the lubricating oil at the cylinder surface so that it returns to crank case. Pistons ring details:                                                                                     Fig:  Piston rings   Rings seal the compression in the combustion chamber and the motor oil in the crankcase. Automotive engines use 3 rings: 2 compressions and 1 multi-piece oil ring. Rings are usually made of cast iron Can be plated with chrome or molybdenum. Help seal the ring to the cylinder wall. Shapes of the ring vary to also help the ring seal better.     Piston Ring Wear: Causes a loss of compression.                  Causes excessive oil consumption. May cause blue smoke out the tail pipe. Types of the piston rings: There are six types of the p
next page

TYPES OF GEAR BOX

Image
Introduction:                  For selecting a gearbox, its structure type, installation form, bearing capacity, output rotational speed, working conditions and other factors shall be considered.   Types of the gear box: (a) Selective type gear boxes:                 (i) Sliding mesh gear box                 (ii) Constant mesh gear box                 (iii) Synchromesh gear box (b) Progressive type gear box (c) Epicyclic type gear box. Sliding Mesh Gear Box:    It is simplest type of gear box out of the available gear boxes. In this type of gear box, gears are changed by sliding one gear on the other. This gear box consists of three shafts; main shaft, clutch shaft and a counter shaft. In a four speed gear box (which includes one reverse gear), the counter shaft has four gears which are rigidly connected to it. Clutch shaft has one gear and main shaft has two gears. The two gears on the main shaft can slide in the horizontal direction along the splines of the main shaft. However, the g
next page

LAYOUT OF AN AUTOMOBILE CHASSIS-1

Image
Automobiles or vehicles can be classified on different bases as On the Basis of Load, On the Basis of Load, On the Basis of Load, Fuel Used, Body, Transmission, and Position of Engine. Classification:    On the Basis of Load (a)    Heavy transport vehicle (HTV) or heavy motor vehicle (HMV), e.g. trucks, buses, etc. (b)   Light transport vehicle (LTV), e.g. pickup, station wagon, etc. (c)    Light motor vehicle (LMV), e.g. cars, jeeps, etc. Wheels (a)    Two wheeler vehicle, for example: Scooter, motorcycle, scooty, etc. (b)   Three wheeler vehicle, for example: Auto rickshaw, three wheeler scooter for handicaps and tempo, etc. (c)    Four wheeler vehicle, for example: Car, jeep, trucks, buses, etc. (d)   Six wheeler vehicles, for example: Big trucks with two gear axles each have four wheels.   Fuel Used (a)    Petrol vehicle, e.g. motorcycle, scooter, cars, etc. (b)   Diesel vehicle, e.g. trucks, buses, etc. (c)    Electric vehicle which use battery to drive. (d)   Steam vehicle, e.g.
next page