GRADIENT RESISTANCE

Introduction:
                The gradient resistance or downhill force relates to the slope descending force and is calculated from the weight acting at the center of gravity.

 

 

Gradient resistance:
                                               

FSt =mF g sinαSt
 

The road gradient q is defined as the quotient of the vertical and horizontal projections of the roadway. When designing roads, gradients of more than 7% are normally avoided.

SinαSt ≈ tanαSt = q/100

  • Except in extreme cases, the following approximation is valid:

 

 

 

 Fig: Forces acting on the vehicle travelling uphill

Comments

Post a Comment

Popular posts from this blog

PISTON RINGS

Image
Introduction: Piston rings are provided on the piston. These are used to seal the high pressure side (cylinder) and low pressure side (crank case), i.e. to prevent leakage of gases. There is one oil ring also which is used to scrap the lubricating oil at the cylinder surface so that it returns to crank case. Pistons ring details:                                                                                     Fig:  Piston rings   Rings seal the compression in the combustion chamber and the motor oil in the crankcase. Automotive engines use 3 rings: 2 compressions and 1 multi-piece oil ring. Rings are usually ...
next page

LAYOUT OF AN AUTOMOBILE CHASSIS-1

Image
Automobiles or vehicles can be classified on different bases as On the Basis of Load, On the Basis of Load, On the Basis of Load, Fuel Used, Body, Transmission, and Position of Engine. Classification:    On the Basis of Load (a)    Heavy transport vehicle (HTV) or heavy motor vehicle (HMV), e.g. trucks, buses, etc. (b)   Light transport vehicle (LTV), e.g. pickup, station wagon, etc. (c)    Light motor vehicle (LMV), e.g. cars, jeeps, etc. Wheels (a)    Two wheeler vehicle, for example: Scooter, motorcycle, scooty, etc. (b)   Three wheeler vehicle, for example: Auto rickshaw, three wheeler scooter for handicaps and tempo, etc. (c)    Four wheeler vehicle, for example: Car, jeep, trucks, buses, etc. (d)   Six wheeler vehicles, for example: Big trucks with two gear axles each have four wheels.   Fuel Used (a)    Petrol vehicle, e.g. motorcycle, scooter, cars, etc. (b)...
next page

TYPES OF GEAR BOX

Image
Introduction:                  For selecting a gearbox, its structure type, installation form, bearing capacity, output rotational speed, working conditions and other factors shall be considered.   Types of the gear box: (a) Selective type gear boxes:                 (i) Sliding mesh gear box                 (ii) Constant mesh gear box                 (iii) Synchromesh gear box (b) Progressive type gear box (c) Epicyclic type gear box. Sliding Mesh Gear Box:    It is simplest type of gear box out of the available gear boxes. In this type of gear box, gears are changed by sliding one gear on the other. This gear box consists of three shafts; main shaft, clutch shaft and a c...
next page